Unit Assembly Prior To Installation - Regency City CP60E Owners & Installation Manual

page of 108

/ 108
Contents
Table of Contents
Bookmarks

Table of Contents

Unit Assembly Prior to Installation

Warning: Do not remove two transportation supports until framing

and finishing are done.

Before you start - removing the unit from the pallet

Remove the screws securing the unit to the pallet.

Due to the CP60E's size and weight (617 pounds/280 kg shipping weight),

Unit Assembly Prior to Installation

lifting and moving the unit requires 4 people.

Before you start

Place a 2 x 4 long enough to provide a solid grip on the backside of the unit

Removing the unit from the pallet

as shown. Place another 2 x 4 through the unit as shown below.

Lift and move the unit carefully.

Remove the screws securing the unit to the pallet

Due to the size and weight (480 pounds shipping weight) of the CV60E--lifting

and moving the unit will require 4 people.

Place a length (long enough to get a solid grip on each side) of 2 x 4 under

the handle on each side.

Lift and move the unit carefully.

Note : When in position, the handles may be removed from the unit by removing

6 screws on each handle. Ensure that when the handles are removed that the

screws are put back into place in all 12 holes locations where the handle had

been previously (6 per side). The handles can be recycled.

Side stando assembly CV60E

When the unit is in position, detach the back handle by removing 6

The CV60E has 4 stando s, 2 on each side that need assembly before installing.

screws. Ensure the screws are replaced in the holes they were removed

The stando s are shipped in a ﬂat position -- fold the stando and install the

stando onto the unit by sliding the 2 tabs into the slots on the unit. Bend the

from. The handle is recyclable.

tabs to secure. Secure opposite end of the stando with one screw.

Rear Standoffs

The two top rear standoffs are designed so that screws can be used to secure

the appliance to the rear wall if needed. Studs must be in place for this opera-

tion. The flanges (see image opposite) are the standoffs.

CV60E

Rear Stando s

Levelling Legs

The 2 top rear stando s are designed so that screws can be used to secure

the appliance to the rear wall if needed. Studs must be in this location if

choosing to screw this into studs.

There are two levelling legs on each side that can be adjusted with the tool

found in the manual package.

Leveling Legs

There are four levelling legs - two on each side that can be adjusted (with the

supplied tool--found in the manual package) if required.

tooltip

3RD ANGLE

TOLERANCES UNLESS

PROJECTION

OTHERWISE STATED

DIMENSIONS

0.000 = 0.01 CRITICAL

0.000 = SPECIFIED TOLERANCE

DO NOT SCALE

0.000 = 0.031

DRAWING

0.000 REF = REFERENCE ONLY

UNITS IN INCHES

ANGULAR = 1

THIS DRAWING IS THE PROPERTY OF FPI LTD., IT MAY NOT BE COPIED IN WHOLE OR IN PART, OR DISCLOSED TO A THIRD PARTY WITHOUT OUR PRIOR WRITTEN CONSENT.

Levelling Legs

installer's information

Handle at the back

of the unit

FIREPLACE PRODUCTS

MAT'L :

INTERNATIONAL

SHEAR/ PUNCH/ FORM

PROCESS :

1:24

CP60 MAIN ASSEMBLY

SCALE:

PART :

11/17/2021

MEDRALIN

DWN:

DATE:

E.C.N.:

SIGN:

3RD ANGLE

PROJECTION

DO NOT SCALE

DRAWING

UNITS IN INCHES

City Series CP60E |

Leveling legs

PART NO:

REV:

457-500

Flanges