Installing The Paper Roll - Royal Alpha5000ML Instruction Manual

Installing the Paper Roll

Alpha5000ML owner's manual
Your cash register has two thermal printers that print receipts for the customer and a
journal tape. Use 2¼ inch (57/58 mm) wide standard thermal register paper when
replacement paper is necessary. Do not use bond paper because the register does not
use a ribbon or ink for printing.
Caution
Do not manually pull the receipt paper. Always use the feed keys to
remove or advance the paper. Do not use sharp or pointed instruments in
the printer area. This can seriously damage the printer.
1 If prompted by the register or during initial setup open the printer compartment
by lifting up on the tabs located towards the back of the register. This will
expose the printers.
2 Depending on the printer side which is out of paper, use the release buttons to
open the paper wells and release the print rollers.
3 Drop the paper into the paper well so it feeds from the bottom of the roll towards
the front of the cash register (if the paper is placed incorrectly, the printer will
NOT print). Pull the paper up and past the printer heads towards the front of the
cash register.
4 Once finished, close the printer arms and use the feed keys to advance the paper.
5 To attach the journal roll to black winding wheel, remove the wheel from the
printer compartment. Make a small fold on the end of the journal roll and feed it
under and around the tabs located on the winding wheel. Spin the winding
wheel manually to take up an excess paper.
10