Installing The Paper Roll - Royal Alpha 583cx User Manual

Installing the Paper Roll

Your cash register has a thermal printer that prints receipts for the
customer or a journal tape. You can use 2¼ inch (57.5 mm) wide standard
thermal register paper.
To install the paper roll
1 Insert the PRG key and turn it to either REG1 or REG2.
2 Unlock and open the Journal Compartment Cover. Grip the left side of
3 Remove the Journal
4 Grab the small handle on the right
5 Lay the end of the paper across the
6 Do one of the following:
Alpha 583cx User's Guide
abcoffice
• If you need a customer receipt, turn the Mode key to the REG1
position.
• If you do not need a customer receipt, turn the mode key to the REG2
position.
the cover and gently pull upward. Remove the Journal Compartment
Cover and set aside.
Takeup spindle.
Place the paper roll
in the little round
area at the bottom
of the compartment.
Make sure the
paper feeds out
from the bottom of
the roll, towards the
front of the cash
register.
of the print roller. Push the little
handle towards the back of the cash
register and raise the roller bar up.
printer as shown. Move the print
roller down onto the paper and
snap into place. Make sure both
sides are snapped down.
• Press the Feed key until the paper
catches and moves through the printer.
www.abcoffice.com
Installing the Paper Roll
Handle
1-800-658-8788
5