Installing The Paper Roll; Setting The Date And Time - Royal 240DX Instruction Manual

Installing the Paper Roll

Setting the Date and Time

11
Your cash register has a thermal printer that prints receipts for the customer or a
journal tape. Use 2¼ inch (57.5 mm) wide standard thermal register paper. Do not
use bond paper because the register does not use a ribbon or ink for printing.
Caution
Do not manually pull the receipt paper. Always use the Feed key to
remove or advance the paper. Do not use sharp or pointed instruments in
the printer area. This can seriously damage the printer.
1 At the prompt on the clerk display during set up, open the Journal Compartment
Cover. Remove the Journal Compartment Cover and set aside. Remove the tape
on the black Journal Tape spindle inside the printer compartment of the cash
register.
2 Grab the small handle
on the right of the print roller. Push
the little handle towards the back of
the cash register and raise the roller
bar up.
3 Lay the end of the paper across the
printer as shown. Move the print
roller down onto the paper and
snap into place. Make sure both
sides are snapped down.
4 Press the Feed key to move the paper
through the printer to make sure there is
no jam and the paper is properly installed
before continuing.
5 Follow the instructions on the clerk display.
The date changes every day and prints in the month-day-year format. You can
prevent the date from printing on the transaction receipts. The Date Format can also
be changed to print day-month-year/ year-month-day. For more information, see Date
Format on page42.
The time can print in either the 12 or 24 hour (military time) format. The default
setting is to print in the 24 hour format, which is normally used. To change to the 12
hour format, see Time Format on page42. You can set the cash register so that it does
not print the time on receipts. For more information, see Print Parameters on
page39.
Royal 240DX User's Guide