Roland Double Sheet Detector R1000 Series Manual page 95

B0069991 / Rev. 1.7
System parameter 21: Setting the internal system zeroing.
System Parameter: 21
Internal analog Zero
Fig. 91: Setting the internal system zeroing
This parameter is only for the Service personnel.
System parameter 22: Setting the internal system gain.
System Parameter: 22
Internal analog Gain
Fig. 92: Setting the internal system gain
This parameter is only for the Service personnel.
System parameter 23: not available
System parameter 24: not available
System parameter 25: Diagnostic
System Parameter: 25
diagnostic
Fig. 93: Diagnostic factors (fixed)
This system param. is used for the equipment diagnostics and shouldn´t be changed by the user.
System parameter 26: Strength of compensation:
System Parameter: 26
compensation factor
Fig. 94: Compensation strength
Projected parameter.
System parameter 27: System info:
I20-PR-S-4(1)-
SV: 1 HVH: 0 HVA: 0
IN/OUT (no Bus) Unit
Fig. 95: System info
st
1 line: Indication of the system type. The bracketed numeral is the number of activated
sensors, the numeral before is the number of measurement channels (2-channel or 4-
channel).
nd
2 line Indication of the versions of Software (SV) and Hardware (Processor board und Analog
board).
This info field can also be displayed during the regular operation by pressing the ENTER key.
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector-series I20
no
no
0
Manual
Start-up
95