Busyout Cdr-Link - Avaya Definity SI Maintenance Manual

busyout cdr-link

If the specified board is part of the DCS link, the board cannot be busied out
unless the link itself is busied out first. If the DCS link is not busied out, the
following message appears:
If the specified board is an EI board and it is part of the active link, the following
message appears:
Illegal Command for active object; use 'set' to switch to standby
If a busyout is attempted on an invalid board in the service slot, the following
message appears:
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
If during the execution of a command a resource problem occurs that requires the
user to restart the command, then the following message appears:
Command resources busy; Press CANCEL to clear, and then resubmit
If all of the available maintenance resources are currently in use, then the
following message appears:
busyout cdr-link
This command will busyout a maintenance object associated with the specified
call detail recording (cdr)-link.
Help Messages
If the system technician presses
following message appears:
Error Messages
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
555-233-123
Must first busyout SCI link
Board invalid
'login id':'command' has a command conflict
All maintenance resources busy; try again later
HELP
primary
'login id':'command' has a command conflict
after entering "busyout cdr-link," the
secondary
Issue 4 May 2002 A-3