Change Synchronization; Change System-Parameters Maintenance - Avaya Definity SI Maintenance Manual

change synchronization

change synchronization
Help Messages
If the user presses
message appears:
Error Messages
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
change system-parameters
maintenance
This command specifies and displays scheduled maintenance operations and
maintenance support functions. It also activates and deactivates INADS alarm
origination during repairs. To deactivate alarm origination:
1. Make a note of the current entries in the Alarm Origination and CPE Alarm
fields so you can restore them later.
2. Change the Alarm Origination to OSS Numbers field to neither.
3. Change the CPE Alarm Activation Level field to none.
4. If daily scheduled maintenance must remain idle during a maintenance
procedure, set the Start Time field to a time after the session ends. If
daily Scheduled Maintenance is running and needs to be deactivated, set
the Stop Time field to one minute after the current time.
5. Press
Command successfully completed
555-233-123
after entering "change synchronization" the following
HELP
Entry is not required
'login id':'command' has a command conflict.
and verify that the screen displays the message:
Enter
NOTE:
For earlier releases of system software, disable Cleared Alarm
Notification and Restart Notification before submitting the form.
NOTE:
When finished working on the switch be sure to return all fields to
their original settings.
Issue 4 May 2002 A-17