Refresh Spe-Standby; Release Access-Endpoint - Avaya Definity SI Maintenance Manual

Error Messages from Chapter 8: Maintenance
Commands
If the cabinet and carrier specified are in an EPN that is not available, the
following message appears:
If a cabinet number of "1" or "01" is entered and the carrier specified is "A" or "B" in
an SPE duplex system, the carrier specified is "A" in a SPE simplex system or if
the "A" carrier is specified with a cabinet other than "1" or "01, or an SCC carrier
location is given," the following message appears:
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:

refresh spe-standby

Help Messages
If the system technician presses
following message appears:
Entry is not required
Error Messages
If the command entered is in conflict with another currently executing command,
then a message appears showing the login id of the conflicting user and the
conflicting command. The message is as follows:
'login id':'command' has a command conflict

release access-endpoint

Help Messages
If the user presses
message appears:
Enter assigned extension
Error Messages
If the format for the extension is incorrect, the following error message appears:
Extension invalid
A-60 Issue 4 May 2002
EPN is not available
Cannot recycle control carriers or XE carriers
login id':'command' has a command conflict
after entering "refresh spe-standby," the
HELP
after entering "release access-endpoint," the following
HELP
555-233-123