Vc-Dsppt - Avaya Definity SI Maintenance Manual

Maintenance Object Repair Procedures

VC-DSPPT

MO Name (in
Alarm Log) Alarm Level
VC-DSPPT MAJOR
VC-DSPPT MINOR
VC-DSPPT WARNING
1 Where P is the port network number (1 for PPN and 2 or 3 for EPN); C is the carrier designation (for
example, A, B, C, or D); and SS is the address of the slot in the carrier where the circuit pack is
located (for example, 01, 02, ...).
Each Voice Conditioner Circuit Pack (VC-BD) provides two types of resources:
1. Transcoder Resources used for encoding and decoding audio formats
2. Summer Resources used for summing audio from different sources
The eight Voice Conditioner DSP ports are the transcoder resources on the
VC-BD.
Error Log Entries and Test to Clear Values
Table 10-708. VC-DSPPT Error Log Entries
Error Aux
Type Data
1
0 0 Any
18 (a) 0 busyout port PCSSpp
257 (b) Any NPE Crosstalk Test (#6)
513 (c) Any VC DSP Port Local TDM
Loopback Test (#1104)
778 to Any VC Port Reset DSP Test
781 (d) (#1106)
1025 (e)
1281 (f) Any VC DSP Port DSP
Loopback Test #(1105)
3840 (g)
1 Run the short test sequence first. If all test pass, run the long test sequence. Refer to the appropriate
test description and follow the recommended procedures.
Notes:
a. This port has been busied out by the busyout port PCSSpp command.
10-1974 Issue 4 May 2002
Initial Command to Run
test port PCSSpp l r#
test port PCSSpp l r#
test port PCSSpp l r#
Alarm
Associated Test Level
Any
WNG
MIN
MIN
MAJ
WNG
MIN
1
Full Name of MO
Voice Conditioner DSP Port
Voice Conditioner DSP Port
Voice Conditioner DSP Port
On/ Off
Board Test to Clear Value
Any test port PCSSpp sh r 1
OFF release port PCSSpp
ON test port PCSSpp 1 r 3
ON test port PCSSpp sh r 3
ON See note (d)
ON
ON test port PCSSpp sh r 3
555-233-123