Programming A Fleet Map - Radio Shack PRO-94 Owner's Manual

Programming a Fleet Map

1. Set the scanner for conventional scanning. Press
, then press
PROG
2. Press the number key of the bank where you want
to store the fleet map.
3. Repeatedly press V or W until
press . A trunked frequency you previously pro-
E
grammed appears.
4. Press
DATA
5. Repeatedly press V or W until
press .
E
6. Press
DATA
7. Repeatedly press V or W to select the size code
for the first block, then press
block appears.
Block
8. Repeat Step 7 until you have selected a size code
for each desired block.
9. Press
SRC (LIMIT)
programming mode, tunes the data channel, then
searches using the map you programmed.
Note: If you select size code S-12, S-13, or S-14, these
restrictions apply:
• S-12 can only be assigned to Blocks 0, 2, 4, or 6
• S-13 can only be assigned to Blocks 0 and 4
• S-14 can only be assigned to Block 0
Since these size codes require multiple blocks, you will
be prompted for the next available block when you pro-
gram a fleet map. For example, if you assign Block 0 as
S-12, the scanner prompts you for
available, instead of b1. If you assign Block 0 as S-14,
you would not see another prompt because S-14 uses
all available blocks.
60
TRUNK
. A preprogrammed fleet map appears.
.
. The scanner exits the trunking
.
E1 appears, then
USr
appears. Then
. The next available
E
b2 , the next block
Size Code