Programming Motorola 800 Mhz Splinter Systems; Programming Fleet Maps - Radio Shack PRO-96 Owner's Manual

Ô Ô
NOTES
• If the radio appears
to be trunking to the
wrong frequencies
when monitoring an
800 MHz system, you
should try to
configure the system
for splinter operation.
Splinter systems
•
exist only in the 800
MHz band, and only
use the 3600 bps
control channel type.
Setting splinter
configuration on
VHF, UHF, 900 MHz
and 800 MHz APCO-
25 systems will have
no effect.
36
6.25, 7.5, 12.5, 15, 25.0, or
50.0kHz, and then press
.
ENTER
P
ROGRAMMING
M 800 MH
OTOROLA
S S
PLINTER YSTEMS
Certain 800 MHz Motorola trunked
radio systems operate using
splinter channels that are in
between the channels in the
normal 800 MHz band plan. These
systems are known as "splinter
systems". Your scanner features
an offset mode to allow reception
Ô
of these systems.
1. Press , and then
PGM
to enter the ID program mode.
2. If necessary, press
or to select the desired
bank.
3. If necessary, press
select Motorola trunking
mode.
4. Press , and then
FUNC
edit the 3600 CC Mode.
5. Press or to select
Normal Splinter
,
,
Multi Table
, and then press
.
ENTER

Programming Fleet Maps

You must set the fleet map if you
want to receive a Motorola Type I
system. Fleet maps are included
along with other information about
Motorola Type I systems at
www.trunkscanner.com
Follow these steps to program a
fleet map.
Z
TRUNK
then
FUNC
to
MODE
to
3
Table
, or