Manually Storing Talk Group Ids In Talk Group Id Lists - Radio Shack PRO-94 Owner's Manual

up to 10 IDs, for a total of 50 IDs for each trunk scan-
ning bank. If you use all the banks as trunking banks,
you can store 1000 IDs.
Talk group ID lists help you to organize trunking system
users into categories. For example, you might use List
1 for police IDs, List 2 for fire department IDs, List 3 for
emergency medical service IDs, and so on. Once you
store all the IDs in a list, you can scan them just as you
scan conventional channels. You can program IDs into
talk group ID lists manually, during a search, or auto-
matically.
Manually Storing Talk Group IDs
in Talk Group ID Lists
1. Select the trunking bank you want to use (see
"Scanning a Trunked Bank" on Page 46).
2. After the scanner begins trunk scanning, press
. A number showing the current talk group ID
MAN
list appears at the top of the display, and bars
appear that show activity in other banks.
3. Press
MAN
select the talk group ID list location (shown at the
top of the display) where you want to store an ID.
Then press
4. Enter the type of ID you want to store, then press
.
E
To enter a Type I ID , use the number keys to enter
the block number and the fleet number, then press
•
. Enter the subfleet number and press
To enter a EDACS ID , use the number keys to
enter the agency number, then press
the fleet number and the subfleet number, then
press
E.
Note: To clear a mistake while entering an ID,
press then
0
5. Repeatedly press
scan list location you want to program. Then
repeat Step 4 to enter another ID.
6. When you finish, press
then repeatedly press V or W to
again
,
.
PROG
, then start over at Step 1.
E
PROG
E
•
. Next, enter
or V to select the next
to store the entries.
E.
53