Installing The Cable Access Panels (Caps) - AT&T 75 Wiring Manual

Z100-TYPE HARDWARE
CONNECTOR MODULE LABEL ORDERING INFORMATION

Installing the Cable Access Panels (CAPs)

The cable access panels are wall-mounted. A maximum of three panels can be mounted in a
vertical column. To install the cable access panels, proceed as follows:
1. Align the first cable access panel 4 inches (10.2 cm) to the left side and 6 inches
(15.2 cm) above the cross-connect field location (see Figure 2-26).
2. Mark the keyhole mounting screw location in the upper-right corner of the cable
access panel.
Remove the cable access panel, drill a hole in the backboard, and start a 3/4-inch
3.
(19 mm) No. 12 wood screw.
Move the cable access panel back into place and align.
4.
Mark the remaining three keyhole mounting screw locations in the cable access
5.
panel.
6. Remove panel and drill pilot holes in the backboard.
7. Move the cable access panel back into place and fasten to the backboard with the
3/4-inch (19 mm) No. 12 wood screws.
Align next cable access panel 1 inch (2.5 cm) below the previously positioned cable
8.
access panel and repeat steps 2 through 7.
9. If you are installing two columns of cable access panels, position top cable access
panel 4 inches (10.2 cm) to the left of the first column of cable access panels and
repeat procedure from step 2.
2-50
Description Qty. Per Code
101A Labels
102A Labels
103A Labels
104A Labels
105A Labels
106A Labels
107A Labels
108A Labels
109A Labels
110A Labels
111A Labels
112A Labels
113A Labels
114A Labels
115A Labels
116A Labels
117A Labels
118A Labels
119A Labels
120A Labels
121A Labels
122A Labels
123A Labels
Comcode
60 103 969 754
40 103 969 762
40 103 969 770
40 103 969 788
20 103 969 796
10 103 969 804
10 103 969 812
103 969 820
30
10 103 969 838
103 969 846
60
40 103 969 853
40 103 969 861
40 103 969 879
20 103 969 887
100 103 985 131
100 103 985 149
103 985 156
100
10 103 985 164
10 103 985 172
103 985 180
10
10 103 985 198
40 103 985 206
10 103 985 214