General - AT&T 75 Wiring Manual

Z100-TYPE HARDWARE
2. Z100-TYPE HARDWARE—SYSTEM 75 OR SYSTEM 75 XE INSTALLATIONS

GENERAL

Figure 2-1 shows the equipment required to install a System 75 or System 75 XE. A
description and explanation of each piece of equipment follows. Ordering information is
provided at the end of each description.
The sites shown in Figure 2-1 are physical locations (closets) for pass-through connections
where adjunct power may be applied. The satellite is a physical location (closet) where
cross-connect administration can take place and adjunct power may be applied.
* PROVIDED BY THE CABLE ACCESS PANEL (CAP), 110-TYPE
HARDWARE OR 66-TYPE HARDWARE
Figure 2-1. Block Diagram of System 75 or System 75 XE Installation
2-1