User Prog Control; How To Select A User Program; How To Program The User Prog Control - Furuno FSV-25 Operator's Manual

5.3

USER PROG Control

The USER PROG control provides for instant setup of the equipment according to
fishing ground or target fish. Ten programs may be set up, and vertical and horizontal
display settings may be programmed together or individually. (The default settings
programs them together. For how to program them individually see section 5.3.2.)
5.3.1

How to select a user program

Rotate the USER PROG control clockwise or counterclockwise to select the program
no. desired. The program no. selected appears at the top right-hand corner of the
screen to the right of "P". If the equipment is turned off with a user program active, it
starts up with those settings at the next power on.
Note: The user program no. can also be adjusted from the user program no. indica-
tion.
5.3.2

How to program the USER PROG control

1. Set the display appropriately.
When a combination mode is shown, press H/V/S key to select the display to pro-
gram.
2. Press the MENU/ESC key to show the main menu.
3. Click [Others].
4. Click [Register].
Register
Display Mode ...
Sel User Prog
Assign User Prog
Assign User Prog-H
Assign User Prog-V
F-KEY List ...
Clear F-KEY Setting ...
H-Scan Range
V-Scan Range
[Sel User Prog] = [H/V Individual]
*: H/V Interlock: Effective on both H and V displays.
H/V Individual: Select the display to use with the H/V/S key.
H-UP
H R 400m
T 17°
G 1. 0
40
P 8 Put the cursor on the program
setting, which is then highlighted
50
in yellow. Spin the scrollwheel to
change the setting.
Quit
: H/V Individual
5. HOW TO CUSTOMIZE THE SONAR
Register
Display Mode ...
Sel User Prog
Assign User Prog
Assign User Prog-H
Assign User Prog-V
F-KEY List ...
Clear F-KEY Setting ...
H-Scan Range
V-Scan Range
[Sel User Prog] = [H/V Interlock]
Quit
: H/V Interlock
5-7