How To Program The Function Keys Of Remote Controller; User Prog Control; How To Select A User Program - Furuno FSV-25S Operator's Manual

5. HOW TO CUSTOMIZE THE SONAR
5.2.5

How to program the function keys of remote controller

You can program the function keys (F1-F4) on the remote controller (option) to provide
one-touch access to the functions of the keys on the control unit.
The function of the following control unit keys can be assigned to the function keys on
the remote controller.
• V1/S key
• V2 key
• EVENT
• OFF CENTER key
• ESTIMATE 1 (or 2) key
• SHOOT key
• R/B AUDIO key
The default setting of the F1 to F4 key is the same as those on the control unit. To
change a setting, do as follows:
1. Press the F8, F9, and F10 keys in order while pressing the MENU/ESC key to ac-
tivate the program registration mode on the remote controller.
2. Press the MENU/ESC key to close the menu.
3. Press and hold down the applicable key on the control unit and then press a func-
tion key on the remote controller.
When the registration is completed the audio alarm sounds.
4. Operate the function key programmed to confirm functionality.
5. Repeat steps 1 to 4 to program another function key.
5.3

USER PROG Control

The USER PROG control provides for instant setup of the equipment according to
fishing ground or target fish. Ten programs may be set up, and vertical and horizontal
display settings may be programmed together or individually. (The default settings
programs them together. For how to program them individually see section 5.3.2.)
5.3.1

How to select a user program

Rotate the USER PROG control clockwise or counterclockwise to select the program
no. desired. The program no. selected appears at the top right-hand corner of the
screen to the right of "P". If the equipment is turned off with a user program active, it
starts up with those settings at the next power on.
Note: The user program no. can also be adjusted from the user program no. indica-
tion.
5-6
(or ) key
H-UP
H R 400m
T 17°
G 1. 0
40
P 8 Put the cursor on the program
setting, which is then highlighted
50
in yellow. Spin the scrollwheel to
change the setting.
• DELETE MARK key
• TARGET LOCK key
• FISH key
• AUTO TRAIN key
• DISP MODE key
• H/V/S key
• F1 to F4 key