Furuno FSV-25 Operator's Manual page 135

Message
"<<TD WRONG POSITION ALARM!!>>
TRANSDUCER IS KEPT AT WRONG POSITION.
SET BACK TRANSDUCER POSITION TO NORMAL
BY USING ↑ KEY. PRESS R/B KEY TO TURN OFF
ALARM."
"<<OVER TEMPERATURE!!>>
RETRACT TRANSDUCER AND TURN OFF POWER.
PRESS R/B KEY TO TURN OFF ALARM."
"<<TRANSDUCER IS A HALT CONDITION!!>>
TD IS A HALT CONDITION. CAN'T BE OPERATED
UNTIL IT CANCELS. CHECK STOP BUTTON IS
PUSHED OR TAKE OUT HULL UNIT RATCHET."
"<<TD RECOVERED THE HALT CONDITION!!>>
TD RECOVERED THE HALT CONDITION. PRESS
↑↓ KEY, IF SAFETY IS ENSURED. PRESS THE R/B
KEY TO CLOSE THE WINDOW."
"<<SHIP SPD ALARM!!>>
TD IS KEPT EXTENDED. MAX ALLOWABLE SPEED
FOR EXTENDED TRANSDUCER IS XX.X KN. RE-
TRACT TRANSDUCER. PRESS R/B KEY TO TURN
OFF ALARM."
"<<SHIP SPD ALARM!!>>
MAX ALLOWABLE SPEED FOR RAISING/LOWER-
ING TRANSDUCER IS XX.X KN. PRESS R/B KEY TO
TURN OFF ALARM."
When multiple warnings occur at the same time, the warning with the highest priority
is displayed. The order of priority is as follows:
Priority
1 "TRANSDUCER IS A HALT"
2 "TRANSDUCER NOT RETRACTED"*
3 "OVER VOLTAGE"
4 "OVER TEMPERATURE"*
5 "OVER TEMPERATURE"
6 "ELECTRIC CHARGE"*
7 "NO RESPONSE FROM TRANSCEIV-
ER UNIT"
*: These messages are not erased even if a message of higher priority arrives.
Message
8. MAINTENANCE, TROUBLESHOOTING
Meaning, Remedy
Meaning: The transducer is not at its in-
tended position.
Remedy: Silence the buzzer with the R/B
AUDIO key. Use the ↑ key to try to return
the transducer to its intended position.
Meaning: The temperature at the transduc-
er is too high.
Remedy: Silence the buzzer with the R/B
AUDIO key. Use the ↑ key tor raise the
transducer. Turn off the system.
Meaning: The hull unit is stopped because
the emergency stop button in the hull unit
was operated or the ratchet wrench in the
hull unit was removed.
Remedy: Silence the buzzer with the R/B
AUDIO key. Operate the emergency stop
button and/or restore the ratchet wrench to
enable raising, lowering operations.
Meaning: The emergency stop condition at
the hull unit was released.
Remedy: Silence the buzzer with the R/B
AUDIO key.
Meaning: The transducer is kept lowered
when the ship's speed (external input) ex-
ceeds the maximum allowable speed.
Remedy: Silence the buzzer with the R/B
AUDIO key. Lower speed then retract the
transducer.
Meaning: The transducer is raised/lowered
and ship's speed, input by external equip-
ment, exceeds maximum allowable speed.
Remedy: Silence the buzzer with the R/B
AUDIO key. Lower speed, or lower speed
and retract transducer.
Remarks
Message remains on screen until problem is
cleared.
Message remains on screen until problem is
cleared.
Message remains on screen until problem is
cleared.
Message remains on screen until problem is
cleared.
8-9