Supplemental Flight Data; Timer/References Window - Garmin G1000 Pilot's Manual

2.3 SUPPLEMENTAL FLIGHT DATA

Pressing the DFLTS Softkey (a second-level PFD softkey) turns off metric Altimeter display, the Inset
NOTE:
Map, and Wind Data Box. Pressing this softkey does not restore display units to the default settings.
Some displayed information disappears when pitch exceeds +30˚/-20˚ or bank exceeds 65˚. The Altimeter and
Airspeed, Attitude, Vertical Speed, and Horizontal Situation indicators remain on the display and the Bearing
Information and Annunciation windows can be displayed during such situations.
The following information is removed from the PFD (and corresponding softkeys are disabled) when the aircraft
experiences unusual attitudes:
• Traffic Annunciations
• AFCS Annunciations
• Flight director Command Bars
• Inset Map
• Outside Air Temperature
• DME Information Window
• Transponder Data Box

TIMER/REFERENCES WINDOW

Refer to Section 2.2 under the Airspeed Indicator discussion for information on Vspeeds and Section
NOTE:
2.4 for information on the barometric minimum descent altitude.
The Timer/References Window is enabled/disabled in the lower right corner of the PFD by pressing the TMR/
REF Softkey. This window provides access to the following settings:
• Generic Timer
• Vspeed values and flags
• Barometric minimum descent altitude (MDA, DH)
190-00592-02 Rev. A
Figure 2-23 Timer/References Window
Garmin G1000 Pilot's Guide for the Diamond DA40/40F
• System Time
• PFD Setup Menu
• Windows displayed in the lower right corner
• Barometric Minimum Descent Altitude Box
• Vertical Deviation/Glideslope Indicator
• Altimeter Barometric Setting
• Selected Altitude
FLIGHT INSTRUMENTS
2-17