Garmin G1000 Pilot's Manual page 67

Changing the selected GPS CDI setting:
1) Use the FMS Knob to select the AUX - System Setup Page on the MFD.
2) Press the FMS Knob to activate the cursor.
3) Turn the large FMS Knob to highlight the 'Selected' field in the 'GPS CDI' box.
4) Turn the small FMS Knob to highlight the desired setting and press the ENT Key.
BEARING POINTERS AND INFORMATION WINDOWS
When the Arc HSI is displayed, the Bearing Information Windows and pointers are disabled.
NOTE:
Refer to the Audio Panel and CNS Section for information on tuning the radios.
NOTE:
Two bearing pointers and associated information (Figure 2-22) can be displayed on the HSI by pressing
the PFD Softkey then a BRG Softkey. Use the BRG Softkey to cycle through bearing sources (NAV, GPS,
ADF). The pointers are light blue and are single- (BRG1) or double-lined (BRG2); an icon is shown in the
respective information window to indicate the pointer type. The bearing pointers never override the CDI
and are visually separated from the CDI by a white ring (shown when bearing pointers are selected but not
necessarily visible due to data unavailability).
When a bearing pointer is displayed, its associated information window is also displayed. The Bearing
Information windows are displayed to the lower sides of the HSI and show:
• Bearing source (NAV, GPS, ADF)
• Pointer icon (single line for BRG1, double line for BRG2)
• Frequency (NAV, ADF)
• Station/waypoint identifier (NAV, GPS)
• GPS-derived great circle distance to bearing source
If the NAV radio is the selected bearing source and is tuned to an ILS frequency, the bearing pointer is
removed from the HSI and the frequency is replaced with "ILS". If the NAV radio is not receiving the tuned
VOR station, the bearing pointer is removed from the HSI and the frequency displayed in the information
window is replaced with "NO DATA". When NAV1 or NAV2 is the selected bearing source, the frequency is
replaced by the station identifier when the station is within range.
190-00592-02 Rev. A
Figure 2-21 System Setup Page,
GPS CDI Settings
Garmin G1000 Pilot's Guide for the Diamond DA40/40F
FLIGHT INSTRUMENTS
2-15