Garmin G1000 Pilot's Manual page 333

GDC 74A MESSAGE ADVISORIES
Alerts Window Message
GDC1 CONFIG – GDC1 configuration
error. Config service req'd.
MANIFEST – GDC1 software
mismatch. Communication halted.
BACKUP PATH – ADC1 using backup
data path.
GCU 476 MESSAGE ADVISORIES
Alerts Window Message
GCU CNFG – GCU config error.
Config service req'd.
GCU FAIL – GCU is inoperative.
GCU PATH – A GCU path has failed.
MISCELLANEOUS MESSAGE ADVISORIES
Alerts Window Message
FPL WPT LOCK – Flight plan
waypoint is locked.
FPL WPT MOVE – Flight plan
waypoint moved.
TIMER EXPIRD – Timer has expired.
DB CHANGE – Database changed.
Verify user modified procedures.
FPL TRUNC – Flight plan has been
truncated.
APPR VPROF – Approaching VNAV
profile.
APPR TRG ALT – Approaching target
altitude.
LOCKED FPL – Cannot navigate
locked flight plan.
190-00592-02 Rev. A
GDC 74A configuration settings do not match those of backup configuration
memory. The G1000 System should be serviced.
The GDC 74A has incorrect software installed. The G1000 System should be
serviced.
The GDC 74A is using a backup communications data path. The G1000 System
should be serviced when possible.
GCU 476 configuration settings do not match those of backup configuration
memory. The G1000 System should be serviced.
The GCU 476 has failed. The G1000 System should be serviced when possible.
The GCU 476 is using a backup communications data path. The G1000 System
should be serviced when possible.
Upon power-up, the G1000 System detects that a stored flight plan waypoint is
locked. This occurs when an aviation database update eliminates an obsolete
waypoint. The flight plan cannot find the specified waypoint and flags this
message. This can also occur with user waypoints in a flight plan that is deleted.
Remove the waypoint from the flight plan if it no longer exists in any database,
OR
Update the waypoint name/identifier to reflect the new information.
The system has detected that a waypoint coordinate has changed due to a new
aviation database update. Verify that stored flight plans contain correct waypoint
locations.
The system notifies the pilot that the timer has expired.
This occurs when a stored flight plan contains procedures that have been
manually edited. This alert is issued only after an aviation database update.
Verify that the user-modified procedures in stored flight plans are correct and up
to date.
This occurs when a newly installed aviation database eliminates an obsolete
approach or arrival used by a stored flight plan. The obsolete procedure is
removed from the flight plan. Update flight plan with current arrival or approach.
Aircraft is approaching VNAV profile. Prepare to climb or descend to meet VNAV
profile.
Aircraft is approaching target altitude. Prepare to level aircraft.
This occurs when the pilot attempts to activate a stored flight plan that contains
locked waypoint. Remove locked waypoint from flight plan. Update flight plan
with current waypoint.
Garmin G1000 Pilot's Guide for the Diamond DA40/40F
Comments
Comments
Comments
APPENDIX A
A-11