Garmin G1000 Pilot's Manual page 334

Integrated flight deck diamond da40/40f
Hide thumbs Also See for G1000:
Table of Contents

Advertisement

APPENDIX A
MISCELLANEOUS MESSAGE ADVISORIES (CONT.)
Alerts Window Message
WPT ARRIVAL – Arriving at waypoint
-[xxxx]
STEEP TURN – Steep turn ahead.
INSIDE ARSPC – Inside airspace.
ARSPC AHEAD – Airspace ahead less
than 10 minutes.
ARSPC NEAR – Airspace near and
ahead.
ARSPC NEAR – Airspace near – less
than 2 nm.
LEG UNSMOOTH – Flight plan leg
will not be smooth.
APPR INACTV – Approach is not
active.
SLCT FREQ – Select appropriate
frequency for approach.
SLCT NAV – Select NAV on CDI for
approach.
NO WGS84 WPT – Non WGS 84
waypoint for navigation -[xxxx]
TRAFFIC FAIL – Traffic device has
failed.
A-12
Arriving at waypoint [xxxx], where [xxxx] is the waypoint name.
A steep turn is 15 seconds ahead. Prepare to turn.
The aircraft is inside the airspace.
Special use airspace is ahead of aircraft. The aircraft will penetrate the airspace
within 10 minutes.
Special use airspace is near and ahead of the aircraft position.
Special use airspace is within 2 nm of the aircraft position.
The approaching flight plan waypoints are too close to allow for smooth turns.
Prepare for steep turns ahead and expect noticeable course deviations.
The system notifies the pilot that the loaded approach is not active. Activate
approach when required.
The system notifies the pilot to load the approach frequency for the appropriate
NAV receiver. Select the correct frequency for the approach.
The system notifies the pilot to set the CDI to the correct NAV receiver. Set the
CDI to the correct NAV receiver.
The selected waypoint [xxxx] does not use the WGS 84 datum. Cross-check
position with alternate navigation sources.
The G1000 is no longer receiving data from the traffic system. The traffic device
should be serviced.
Garmin G1000 Pilot's Guide for the Diamond DA40/40F
Comments
190-00592-02 Rev. A

Advertisement

Table of Contents
loading

Table of Contents