L2 Mesh - Cal Amp Phantom II Operating Manual

6.1 Configuration
© CalAmp

6.1.4.7 L2 Mesh

L2 stands for layer 2. When enabled, forwarding is performed at the
MAC layer (layer 2) on the master unit. This allows Remote-to-
Remote communications possible. The master unit forwards packets
that are not destined for its own LAN back to the wireless interface.
Packets that contain the master unit destination MAC address are
forwarded to the master unit's Ethernet port, not the wireless
interface. In comparison to Everyone-to-Everyone mode, this mode
consumes less bandwidth and therefore is more efficient.

Submit
Write parameter values into Phantom II memory.

Reset
Restore 'currently' modified parameter values to those
which were previously written into Phantom II memory.
Phantom II
Values
Disable
Disable
Enable
Soft Buttons
69