Appendix B: Upgrade Procedure (Dos Prompt) - Cal Amp Phantom II Operating Manual

Phantom II
Appendix B: Upgrade Process (DOS Prompt)
FTP Firmware Upgrade
To logon, perform the following steps:
Open a command prompt and type "ftp <ip address>" and <enter>.
Login: type "upgrade" and <enter>
Password: type "admin" and <enter>
To upgrade the firmware, perform the following steps:
Type "binary" and <enter>.
The firmware should be saved in your C:\Documents and Settings\<user> folder.
Type "put <filename>" and <enter>.
Allow 1-2 minutes for the upgrade to complete. The Status LED on the front panel can be monitored to de-
termine when the upgrade is complete.
Type "bye" and <enter> to terminate the FTP session.
© CalAmp 155