Specifications - Cal Amp Phantom II Operating Manual

1.0 Overview
Caution: Using a pow er
supply that does not provide
proper voltage or current may
damage the modem.
Tip: Future enhancements of
the Phantom II products may
r equir e higher c ur r ent
requirements than listed. It is
good design practice to over
spec pow er supplies to allow
for future design options.
© CalAmp
1.2 Phantom II Specifications
Electrical/General
Frequency:
Spreading Method:
Band Segments:
Error Detection:
Data Encryption:
Range:
Output Power:
Sensitivity:
Serial Baud Rate:
USB:
Ethernet:
Link Rate:
Network Protocols:
Operating Modes:
Manag em en t:
Diagno stics:
Core Voltage:
902-928MHz*
(* Contact CalAmp for additional frequencies)
Frequency Hopping /DTS
Selectable via Freq. Restriction
32 bits of CRC, ARQ
128-bit WEP/WPA (Canada & USA only)
-AES - Optional 128/256-bit AES Encryption,
Secure Shell, HTTPS (Canada & USA only)
Up to 20+ miles @ 1.2 Mbps
Up to 40+ miles @ 345 kbps
100mW to 1W (20-30dBm)
-101 dBm @ 345 kbps link rate
-97 dBm @ 1.2 Mbps link rate
300 bps to 921 kbps
USB 2.0
10/100 BaseT, Auto - MDI/X, IEEE 802.3
345 kbps or 1.2 Mbps
TCP, UDP, TCP/IP, TFTP, ARP, ICMP, DHCP,
HTTP, HTTPS*, SSH*, SNMP, FTP, DNS, Serial
over IP, QoS
(* Only available in –AES)
Master, Remote, Repeater
Local Serial Console, Telnet, WebUI, SNMP, FTP &
Wireless Upgrade, RADIUS authentication, VLAN
Battery Voltage, Temperature, RSSI, remote
diagnostics
Enclosed: 7-30 VDC
Phantom II
12