Bridge Configuration - Cal Amp Phantom II Operating Manual

6.1 Configuration
STP: Spanning Tree Protocol is
a link management protocol
which will accommodate the
availability of redundant data
paths but inhibit the possibility of
a loop being created: a loop
could create endless traffic
'around' a LAN, consuming much
of the bandwidth.
© CalAmp

6.1.4.5 Bridge Configuration

In most deployments, Spanning Tree Protocol (STP) will not be
required. It does consume a small amount of bandwidth. The
default is 'Off'.
Note that this menu item will not appear if the Phantom II unit is
configured to be a router.
Image 6-13: Network Configuration, Bridge Config. Submenu
Selection of STP operational status within the Phantom II: On or
Off.

Submit
Write parameter values into Phantom II memory.

Reset
Restore 'currently' modified parameter values to those
which were previously written into Phantom II memory.
Phantom II
Spanning Tree Protocol Status
Values
Off
On
Off
Soft Buttons
66