Quick Start; Web Interface; Requirements; Device Connections - Cal Amp Phantom II Operating Manual

2.1 Quick Start

To ensure that the Phantom II unit
is at its DEFAULT factory settings,
once it has powered-up and the
Status LED is ON (after 1 minute),
press and hold the front CFG
button for 8 seconds - the Status
LED will initially blink, then be on
solid, and then the unit will reset.
© CalAmp
This Quick Start Guide will enable you to promptly establish basic IP
connectivity between a pair of Phantom II modems in a point-to-point
(ref. 5.1) configuration.
Note that the units arrive from the factory with a Radio Configuration
of 'Remote' and the Local Network setting configured as 'Static' (IP
Address 192.168.1.254, Subnet Mask 255.255.255.0, and Gateway
192.168.1.1).
2.1 Programming Option 1 - Web Interface

2.1.1 Requirements

To Program your Phantom II using the web interface, you will need:

At least (2) two Phantom II (factory configured) with Power
Adapter and Rubber Ducky Antenna. Each factory configured
Phantom II has the following default settings: 'Remote' with Local
Network Settings 'Static' (IP Address 192.168.1.254, Subnet
Mask 255.255.255.0, Gateway 192.168.1.1)

PC with NIC (Ethernet) card

Ethernet cable. If your PC does not support Auto MDIX, you will
need to use a crossover cable

2.1.2 Device Connections


Connect Rubber Ducky to the antenna port of each Phantom II

Connect power adapters to 120 VAC outlets and to each Phan-
tom II Using an Ethernet cable,

Connect the Phantom II that will be the MASTER device to the
PC NIC

2.1.3 Connecting to the Web Interface


Open a Web Browser and enter the IP Address of the Phantom II
into the URL address line

Press [Enter]

A login window will appear. Enter default user name (admin) and
default password (admin)

Press [Enter]
Phantom II
14