Setting A Transition Limit - Sony DVS-7250 Operation Software

Using the Mix/Effects Banks

Setting a Transition Limit

Normally the range of a transition corresponds to a complete switch from the
old video to the new video. Alternatively, using the transition limit function,
you can restrict the extent to which the transition is executed, so that in the
state corresponding to a 100% movement of the fader lever, the transition is
still incomplete.
For example if you enable this function with a 50% limit setting, the
transition proceeds to the mid-point, then stops.
When this function is enabled, the visual indication of the transition type
selection button in the transition control section which is selected changes
from amber to green.
Setting a transition limit
Carry out the settings for this function in the BKGD/TRANS menu for the
corresponding M/E bank. For example, to set a transition limit for the M/E-1
bank, use the following procedure.
1
2
3
4-18
Chapter 4 Basic Operations for Image Creation
In the menu control section, press the BKGD/TRANS top menu button in
the M/E-1 group.
The M/E-1 BKGD/TRANS menu appears in the menu screen.
Select item 2 (LIMIT/S-MIX).
The LIMIT/S-MIX menu appears.
TRANS
LIMIT
OFF
F1 F2 F3
Function key indications in the LIMIT/S-MIX menu
Press F1 (TRANS LIMIT), turning it on.
F4 F5 F6 F7 F8 F9 F10