Basic Operation For Dme Wipes - Sony DVS-7250 Operation Software

Basic Operation for DME Wipes

Using a DME wipe for a background transition
To use a DME wipe for a background transition, use the following procedure.
1
Select the background video after the transition with the required B-bus
or PST-bus cross-point button.
2
In the transition control section, press the BKGD next transition
selection button, turning it on.
3
Select DME wipe as the transition type.
When specifying single mode, press either the DME 1 or the DME 2
transition type selection button, turning it on, and when specifying dual
mode, press both buttons simultaneously, turning them on.
4
Select the DME wipe pattern, and if required adjust the parameters.
For details of this operation, see the section "DME Wipe Settings" (page
4-91).
5
Use the fader lever or AUTO TRANS button to carry out the transition.
Chapter 4 Basic Operations for Image Creation
4-89