Status Display
Status Display Operation
Displaying the ALL STATUS screen
ALL STATUS
M/E-1
M/E-2
ALL
4-104
Chapter 4 Basic Operations for Image Creation
This section describes the function for displaying the current status of the
selections for transitions and wipes on the M/E banks and the PGM/PST
bank. It also describes how to change signal selections on the auxiliary buses,
and how to set the transition rate.
From among the top menu selection buttons in the menu block, press the
STATS button in the SYSTEM group, and then select the item 5 (ALL).
The ALL STATUS menu appears. This menu shows the status of transitions
and wipes selected on the M/E-1 and M/E-2 banks and the PGM/PST bank.
Selected transition type
For a wipe or DME wipe the pattern is shown.
TRANSITION
WIPE
NORMAL
M/E-1
MIX
BORDER
POS
REVERSE
M/E-2
NORMAL
P/P
ALL STATUS screen
Selected wipe pattern and wipe modifiers
(DIRECTION, EDGE, and POS only)
Selected DME wipe pattern and
DME wipe modifiers
DME WIPE
NORMAL
PROG
1
BORDER
NORMAL
NORMAL
AUX
AUX
TRANS
(1)
(2)
RATE