Table of Contents
Advertisement
Key Control Section
Each M/E bank has two keyers (1 and 2);
the buttons in this section select the keyer
and then control the key operations.
1 Keyer delegation
buttons
2 Key fill and key source
selection buttons
3 Key type selection
buttons
4 KEY INV button
5 Key insert/remove
buttons
1 Keyer delegation buttons
Press the KEY 1 button, turning it on, to
delegate the buttons in the key control
section to keyer 1, and the KEY 2 button
similarly for keyer 2.
..............................................................................................................................................................................
1) In this manual, this is referred to as delegating the
buttons in the key control section to keyer 1 or
keyer 2.
1)
KEY CONTROL
KEY
KEY
1
2
1
2
MATTE
AUTO
DROP
SPLIT
BORD
FILL
SEL
BORD
LUM
LIN
PTM
CLEAN
CHR
KEY
KEY
KEY
MIX
ON
MIX
KEY1
9 PROC KEY button
Key control section
On a BKDS-7025, pressing one of the
keyer delegation buttons, turning it on, not
only delegates the buttons in the key
control section, but also delegates the
cross-point buttons in the K row to the key
1 bus or key 2 bus as the case may be.
Holding down any one of these buttons for
at least one second outputs the key source
signal from the corresponding keyer to the
EDIT PVW bus. ("Show key" function)
For details, see page 14-30).
6 Key snapshot buttons
7 Edge type selection
buttons
4
3
OUT
SHDW
LINE
KEY
PROC
IMV
KEY
KEY
ON
KEY2
8 Key parameter
setting knobs and
displays
Chapter 2 Location and Function of Parts
2-13
Advertisement
Table of Contents
