Table of Contents
Advertisement
Signal Selection
Pressing a cross-point button selects a signal on the corresponding bus, but in
some cases a single row of cross-point buttons is used for more than one bus.
In this case it is first necessary to delegate the row of cross-point buttons to
the required bus. The next section describes which rows of cross-point
buttons belong to which buses.
For details of the assignment of signals to cross-point button columns, see
page 4-8.
Cross-point buttons and buses
The relation between cross-point buttons and buses depends on the model of
control panel, as shown in the following tables.
Bus
Background A
Background B
Key 1 and key 2 fill
Key 1 and key 2
source
Program
Preset
DSK1 fill
DSK2 fill
Cross-point buttons and buses for the BKDS-7025
Button row Banks
A
M/E-1, M/E-2
B
K
M/E-1, M/E-2
K
M/E-1, M/E-2
Auxiliary bus cross-point buttons
PGM
PGM/PST
PST
DSK
PGM/PST
Chapter 4 Basic Operations for Image Creation
Delegation operation
None required.
Press the KEY 1 or
KEY 2 button in the
corresponding key
control section, turning
it on.
Press the KEY 1 or
KEY 2 button in the key
control section of the
relevant M/E bank to
delegate the
corresponding keyer,
then hold down the
SPLIT button.
None required.
Press the DSK 1 or
DSK 2 button in the
downstream keyer
control section, turning
it on.
(Continued)
4-5
Advertisement
Table of Contents
