Oki MC160MFP Maintenance Manual page 75

Oki Data CONFIDENTIAL
8. Confirm that [FIRMWARE UPDATE OK] message has been displayed, and turn OFF/
ON the machine's main switch.
FIRMWARE UPDATE
FIRMWARE UPDATE OK
MACHINE POWER OFF/ON
9. Print [CONFIGURATION PAGE] to confirm the Controller Firmware Version.
See P.100
44292401TH Rev.1
A0FDF2C530DA
7. Other
6. Other
7.1 6.1 Disassembly/adjustment prohibited items Disassembly/adjustment prohibited items
A. Paint-locked screws
NOTE
• To prevent loose screws, a screw lock in blue or green series color is applied to
the screws.
• The screw lock is applied to the screws that may get loose due to the vibrations
and loads created by the use of machine or due to the vibrations created during
A0FDF3C531DA
transportation.
• If the screw lock coated screws are loosened or removed, be sure to apply a screw
lock after the screws are tightened.
B. Red-painted screws
NOTE
• The screws which are difficult to be adjusted in the field are painted in red in order
to prevent them from being removed by mistake.
• Do not remove or loosen any of the red-painted screws in the field. It should also
be noted that, when two or more screws are used for a single part, only one repre-
sentative screw may be marked with the red paint.
C. Variable resistors on board
NOTE
• Do not turn the variable resistors on boards for which no adjusting instructions
are given in Adjustment/Setting.
D. Removal of PWBs
CAUTION
• When removing a circuit board or other electrical component, refer to "Handling of
PWBs" and follow the corresponding removal procedures.
• The removal procedures given in the following omit the removal of connectors and
screws securing the circuit board support or circuit board.
• Where it is absolutely necessary to touch the ICs and other electrical components
on the board, be sure to ground your body.
MAINTENANCE
74 /