Oki MC160MFP Maintenance Manual page 124

Oki Data CONFIDENTIAL
13.3.6 CNG LEVEL
14.3.6 CNG LEVEL
Function
• Calling tone output level.
Use
• The default setting is -11 dBm.
Setting/
procedure
-17 to -12 dBm ~ "-11 dBm" ~ -10 to -2 dBm
13.3.7 14.3.7 CED LEVEL CED LEVEL
Function
• Answer tone output level.
Use
• The default setting is -11 dBm.
Setting/
procedure
-17 to -12 dBm ~ "-11 dBm" ~ -10 to -2 dBm
13.3.8 14.3.8 ECM MODE ECM MODE
Function
• Select error correction mode.
Use
• The default setting is ON.
Setting/
"ON": When an error occurs during communication, re-send the frame where the
procedure
error occurs.
OFF: Any error is ignored during communication.
13.3.9 14.3.9 CODING SCHEME CODING SCHEME
Function
• Select compression method in TX/ RX mode.
Use
• The default setting is JBIG.
MMR: A compression method.
Setting/
MR: A compression method.
procedure
MH: The simplest compression method.
"JBIG": The most complex compression method that generates the smallest code
than any of following ones.
44292401TH Rev.1
13.3.10 TONER EMPTY REPORT
14.3.10 TONER EMPTY REPORT
Function
• Select to generate a report to a specific destination when toner empty status occurs in
the engine.
Use
• The default setting is OFF.
ON: Generate a report to report destination.
"OFF": Not to generate report.
• If "ON" is selected, select generate report and send to remote side when toner runs out.
Setting/
• Enter the telephone number for which the report is to be produced.
procedure
• Fax number specifications: An up-to-20-digit number that may consist of [0-9], [*], [#],
[pause], and [space]. (0-9, #, *, pause, _)
• The report will generate after 20 minutes, 24 hours, 48 hours, or 72 hours after the event
has occurred or until the condition is gone.
A. Toner empty report (example)
SERVICE REPORT
NAME:ABC 123
TEL:1234567
DA TE: Jun 10.2008 15:12
The Fax's following conditions were appears, the machine may be can not work correctly, the Fax
already send a report to your dealer automatically. They will contact with you soon.
Toner Cartridge Cyan : Empty
Toner Cartridge Magenta : Full
Toner Cartridge Yellow : Full
Toner Cartridge Black : Full
13.3.11 14.3.11 PROTOCOL REPORT PROTOCOL REPORT
Function
• Print communication report.
• Choose one from among the following.
Use
• The default setting is OFF.
Setting/
"OFF": Disable T.30 communication report.
procedure
ON: Print T.30 communication report.
ON (ERROR): Print T.30 communication report when an error occurs.
14.3.12 GDI TIMEOUT
13.3.12 GDI TIMEOUT
Function
• To specify the time for GDI time out.
Use
• The default setting is 60 sec.
Setting/
procedure
5 sec / 10 sec / 20 sec / 30 sec / 40 sec / 50 sec / "60 sec"
ADJUSTMENT/SETTING
A0FDF3C500DA
123 /