Wiring Harness, Battery; Changing The Main Fuse - KTM 450 EXC EU 2013 Repair Manual

15
WIRING HARNESS, BATTERY
Cha!.ll(ing IIIe main fuse
Warning
Fire hazard
The electrical system can be overloaded if the wrong fuses are used.
- Use only fuses with the prescribed amperage. Never by-pass or repair fuses.
• Info
I
The main fuse protects all power consumers of the vehicle. It is located in the starter relay housing under the air filter box
cover.
Preparatory work
- Switch off all power consumers and the engine.
- Remove the air filter box lid. (-- p. 88)
Main work
- Remove screw
- Lift
rear fairing slightly and pull starter relay out of the holder.
- Remove protection caps
- Remove the faulty main fuse
• Info
I
A defective fuse can be identified by the burned-{)ut fuse wire
A reserve fuse is located in the starter relay.
- Install a new main fuse.
1
Fuse (58011109120) (-- p. 218)
- Check that the electrical equipment is functioning properly.
• Tip
I
Insert the spare fuse so that it is available if needed.
- Mount the protection caps.
- Mount the starter relay onto the holder and lay the cable.
- Position the rear fairing. Mount and tighten the screw.
Guideline
112
1
Remaining screws, chassis
1
M6
110
Nm (7.4 Ibf It)
1
Finishing work
- Install the air filter box lid. (-- p. 88)