Table of Contents
Advertisement
9
SHOCK ABSORBER, SWINGARM
-
Position the new heim joint.
-
Mount special tool
I
Mounting tool, heim joint (50329000044)
(--
p. 295)
-
Press in the heim joint by screwing in the screw.
-
Press in shaft seal rings
on both sides with the open side facing inward.
•
Info
I
The heim joint for the shock absorber at the swingarm is Teflon coated. It
must not be greased with grease or with other lubricants. Lubricants dis-
solve the Teflon coating, thereby drastically reducing the service life.
-
Mount spacers
on both sides.
-
Position the shock absorber.
-
Mount and tighten screw
Guideline
Screw, bottom shock
absorber
•
Info
M12
80 Nm
(59 Ibf ft)
Loctitee 2701
I
Raise the wheel slightly to make it easier to mount the screw.
Finishinl work
-
Remove the motorcycle from the lift stand.
(--
p. 12)
84
Advertisement
Table of Contents
