Testing New Batteries - Powerware 9125 User Manual

4. Unscrew and set aside the battery retaining bracket.
5. Pull the batteries out onto a flat, stable surface. See "Recycling
6. Slide the new batteries into the UPS.
7. Reinstall the battery retaining bracket removed in Step 4.
8. Reconnect the battery cable.
9. Snap the LED panel into place.
10. Replace the front panel.

Testing New Batteries

Press and hold the
After the five-second test is complete, the
(it may take a few seconds to turn off). If the
check the battery connections. Call your service representative if the
problem persists.
Powerware 9125 User's Guide (2500–3000 VA)
®
Battery Retaining Bracket
the Used Battery" on page 62 for proper disposal.
button for three seconds to initiate a self-test.
:
Rev B www.powerware.com
UPS Maintenance
indicator should turn off
indicator stays on,
61