Powerware 9125 User Manual page 39

3. Remove the terminal block cover and the wiring knockouts (see
4. Pull the input and output wires through separate conduit,
5. Insert each conduit through a wiring access entry and attach
Powerware 9125 User's Guide (2500–3000 VA)
®
Terminal Block Cover
Figure 17. Typical Hardwired UPS Installation
Figure 18). Retain the terminal block cover.
Input Wiring Access
Figure 18. Wiring Access and Terminal Block
leaving approximately 2 ft (0.5m) of exposed wire. Attach a
flexible metal fitting to the end of each conduit.
the conduit fitting to the panel. Strip 0.52 (1.5 cm) of
insulation from the end of each incoming wire.
:
Rev B www.powerware.com
Communication Port
Output Wiring Access
Terminal Block Cover Screws
Installation
33