Powerware 9125 User Manual page 37

4. On 208V/230V models, plug the detachable UPS power cord
5. Plug the UPS power cord into a power outlet. All front panel
6. Press the On button (see Figure 27 on page 42). The
NOTE The batteries charge to 90% capacity in approximately 3 hours. However, it is
recommended that the batteries charge for 24 hours after installation or long-term
storage.
Powerware 9125 User's Guide (2500–3000 VA)
®
into the input connector on the UPS rear panel.
indicators flash briefly and the UPS conducts a self-test.
When the self-test is complete, the
indicating the UPS is in Standby mode with the equipment
offline. If the or indicator flashes, see page 69.
Battery Service
Indicator
Figure 16. Fault Indicators
indicator stops flashing and the bar graph indicators display the
percentage of load being applied to the UPS.
The UPS is now in Normal mode and supplying power to your
equipment.
:
Rev B www.powerware.com
Installation

indicator flashes,
Site Wiring Fault
Indicator

31