Initiating The Self-Test; Operating Modes - Powerware 9125 User Manual

Operation

Initiating the Self-Test

NOTE The batteries must be fully charged and the UPS must not be in Battery mode
to perform the self-test.
Press and hold the
During the five-second test, the bar graph indicators cycle through
twice. If the UPS finds a problem, an LED indicates where the problem
is. For more information, see "Troubleshooting" on page 67.

Operating Modes

Powerware 9125's front panel indicates the UPS status through the UPS
indicators. Figure 27 shows the UPS front panel indicators and controls.
Normal Mode Indicator
Battery Mode Indicator
Bypass Mode Indicator
Test/Alarm Reset Button
42
button for three seconds to initiate the self-test.
Off Button On Button
Figure 27. UPS Front Panel
Powerware 9125 User's Guide (2500–3000 VA)
®
Alarm Indicators (see page 67)
Bar Graph Indicators
Indicator Legend
Unlit
Lit
Flashing
:
Rev B www.powerware.com