Commissioning On Profinet Io; Configuring The Et 200S On The Profinet Io - Siemens SIMATIC ET 200S Operating Instructions Manual

Note
All interface modules support the default startup. In other words, configuration using the
GSD file or HW Config is not necessary.
The following conditions then apply:
• Preset parameters are used.
• AKF (general identifier format in compliance with the PROFIBUS standard) in the
• Grouping (packing) of the electronic modules is not possible without parameterization.
• All supply voltages on the power modules must be switched on.
• It is not possible to remove or insert modules during operation.
Reference
You can find information regarding the parameter assignment of electronic modules in the
Device Manual ET 200S
under "Parameter for ...".
6.3

Commissioning on PROFINET IO

6.3.1

Configuring the ET 200S on the PROFINET IO

Introduction
The interface module IM151-3 requires a unique device name in order to operate at an IO
controller (refer to the following chapter).
Configuration involves configuring and assigning parameters to the ET 200S.
● Configuration: The systematic arrangement of the different ET 200S modules (setup).
● Assigning parameters: Defining the ET 200S parameters with the configuration software.
GSD file
You configure the ET 200S using the GSD file. This file is used to integrate the ET 200S in
your system as an IO device. You can download the GSD file for ET 200S from the Internet
(http://support.automation.siemens.com/WW/view/en/19699080):
The following GSD file is available for the IM151-3 interface module:
GSDML-Vx.y-Siemens-ET200S-"Date in yyyymmdd format".xml
You can find further information about the procedure in the
ET 200S
Operating Instructions, 08/2008, A5E00515771-06
configuration frame
in the chapters
Note
The ET 200S can be operated with
6.3 Commissioning on PROFINET IO
Digital Analog electronic Modules
or
STEP 7
V5.3 Service Pack 3 and higher.
STEP 7
Commissioning
in each case
Online Help.
115