Profinet Io; Configuring The Et 200Eco Pn M12-L - Siemens SIMATIC ET 200eco PN M12-L System Manual

Configuring

8.3 PROFINET IO

8.3 PROFINET IO
Introduction
By configuring, parameterizing and connecting the individual hardware components of the
ET 200eco PN M12‑L distributed I/O devices, you determine their configuration (preset
configuration) and their mode of operation. You perform the work needed for this in STEP 7
in Devices & Networks.
"Configuring" refers to the arranging, setup and networking of devices and modules within
the Devices & Networks of STEP 7. STEP 7 graphically represents the I/O devices.
"Assigning parameters" refers to the setting of the properties of the I/O devices used.
STEP 7 compiles the hardware configuration (the result of "Configuring" and "Assigning
parameters") and loads the configuration into the IO controller and/or into I/O devices of the
plant.
8.3.1

Configuring the ET 200eco PN M12-L

Introduction
You configure and assign parameters to the ET 200eco PN M12‑L distributed I/O device with
STEP 7 or in the configuration software of another manufacturer.
Requirements
Table 8-1 Requirements for installation
Configuration software
STEP 7 (TIA Portal) as of V16 with
HSP 0299
STEP 7 TIA Portal as of V14
STEP 7 V5.6 or higher
Software of another manufacturer
Configuring the ET 200eco PN M12‑L with STEP 7 TIA Portal
Information on the configuration can be obtained from the STEP 7 online help and in the
SIMATIC PROFINET with STEP 7
(https://support.industry.siemens.com/cs/ww/en/view/49948856) system manual.
Configuring the ET 200eco PN M12‑L with STEP 7 Classic
The procedure for STEP 7 Classic can be found in the manual Programming with STEP 7
(https://support.industry.siemens.com/cs/ww/en/view/109751825).
68
Requirements
PROFINET
PROFINET GSD file
PROFINET GSD file
Installation information
STEP 7 online help
The GSD versions are largely downward com­
patible.
STEP 7 online help
Manufacturer documentation
Distributed I/O system ET 200eco PN M12-L
System Manual, 11/2023, A5E48753295-AG