Wiring Terminal Modules With Fast Connect - Siemens SIMATIC ET 200S Operating Instructions Manual

5.4.4

Wiring terminal modules with Fast Connect

Introduction
● In the case of terminal modules with Fast Connect, the individual wires are attached
● Fast Connect is a connection method that requires no conductor preparation
● Each terminal of the terminal module with Fast Connect has a test opening
● Wire end ferrules are not permitted.
● Diagram of the Fast Connect terminal module
①
②
③
④
Requirements
● Follow the wiring rules.
Required tools
Screwdriver with 3 mm blade
ET 200S
Operating Instructions, 08/2008, A5E00515771-06
using a quick connection method that requires no stripping.
(i. e., the conductor insulation does not have to be stripped).
(e.g. for measuring the voltage). The test opening is suitable for test probes with a
maximum diameter of Ø 1.5 mm.
1
2
3
4
Opening for measuring and testing: max. Ø 1.5 mm
Opening for 1 conductor: 0.5 ... 1.5 mm
Slider open (the cable can be inserted)
Locking mechanism closed (the wire is connected)
2
Wiring and assembly
5.4 Wiring the ET 200S
81