Plugging And Removing Electronic Modules And Compact Modules; Plug And Label Electronic Or Compact Modules - Siemens SIMATIC ET 200S Operating Instructions Manual

5.5

Plugging and removing electronic modules and COMPACT modules

5.5.1

Plug and label electronic or COMPACT modules

Introduction
● The electronic modules or COMPACT modules are inserted in the terminal modules.
● A labeling strip allows you to identify the electronic modules or COMPACT modules.
● Electronic and COMPACT modules are:
Requirement
Observe the rules regarding inserting electronic modules as detailed in the
Planning
Inserting electronic and COMPACT modules
1. Insert the electronic module or COMPACT module into the terminal module until you hear
2. For identification purposes, pull the labeling strip
3. Then reinsert the labeling strip back into the electronic module or COMPACT module.
ET 200S
Operating Instructions, 08/2008, A5E00515771-06
5.5 Plugging and removing electronic modules and COMPACT modules
– Self-coding
– Type-coded
The first time you insert an electronic or COMPACT module, a code element engages on
the terminal module. This mechanically prevents the wrong electronic module or
COMPACT module from being inserted.
chapter.
it snap into place.
– upward out of the electronic module.
– to the right out of the COMPACT module.
You have to lift the labeling strip to the right above the notch (with a 3 mm
screwdriver).
Wiring and assembly
Application
95