Brake Bleeding / Fluid Change - Polaris 2014 Sportsman 570 EF Service Manual

Brake Bleeding / Fluid Change

NOTE: When bleeding the brakes or replacing the
fluid, always start with the caliper farthest from the
master cylinder.
CAUTION
Always wear safety glasses during these procedures.
Brake fluid will damage finished surfaces. Do not allow
brake fluid to come in contact with finished surfaces.
NOTE: Do not remove brake lever when reservoir
fluid level is low.
This procedure should be used to change fluid or bleed
brakes during regular maintenance.
1. Clean reservoir cover thoroughly.
2. Remove screws, cover and diaphragm (C) from
reservoir.
3. Inspect vent slots (A) in cover and remove any debris
or blockage.
4. If changing fluid, remove old fluid from reservoir with
a Mity Vac® pump (PN 2870975) or similar tool.
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
5. Begin bleeding procedure with the caliper that is
farthest from the master cylinder. Install a box end
wrench on caliper bleeder screw. Attach a clean,
clear hose to fitting and place the other end in a
clean container. Be sure the hose fits tightly on
fitting.
NOTE: Fluid may be forced from supply port (B)
when brake lever is pumped. Place diaphragm
(C) in reservoir to prevent spills. Do not install
cover. See Illustration above.
6. Slowly pump the brake lever until pressure builds
and holds.
7. While maintaining lever pressure, open bleeder
screw. Close bleeder screw and release brake lever.
NOTE:
screw is tight or air may be drawn into caliper.
8. Repeat procedure until clean fluid appears in bleeder
hose and all air has been purged. Add fluid as
necessary to maintain level in reservoir.
Maintain at least 1/2", (1.27 cm) of brake fluid
9. Tighten bleeder screw securely and remove bleeder
hose. Torque the bleeder screw to specification.
© Copyright 2013 Polaris Sales Inc.
Do not release lever before bleeder
CAUTION
in the reservoir to prevent air from
entering the master cylinder.
Bleeder Screw:
25-30 in-lbs (2.80-3.40 Nm)
BRAKES
9
9.7