Brake Bleeding / Fluid Change - Polaris RZR XP Service Manual

BRAKE SYSTEM

BRAKE BLEEDING / FLUID CHANGE

IMPORTANT
Bleed the right rear caliper first, followed by the left rear,
front right, and finally the front left caliper.
CAUTION
Always wear safety glasses when handling chemicals
and fluids.
CAUTION
Brake fluid will damage finished surfaces. Do not allow
brake fluid to come in contact with finished surfaces.
1. Clean master cylinder reservoir cover thoroughly and
w
remove the cover .
2. If changing fluid, remove old fluid from reservoir
with a Mity Vac™ pump or similar tool.
Mity Vac™:
2870975
9.10
3. Add brake fluid to the indicated MAX level of
reservoir.
Polaris DOT 4 Brake Fluid
4. Bleed the brakes in the following order: right rear, left
rear, right front and finally the left front. Install a box
end wrench on caliper bleeder screw. Attach a clean,
clear hose to fitting and place the other end in a
clean container. Be sure the hose fits tightly on
fitting.
5. Have an assistant slowly pump foot pedal until
pressure builds and holds.
6. Hold brake pedal down to maintain pedal pressure,
and open bleeder screw
bleeder screw and release pedal.
q
Do not release foot pedal before bleeder screw is tight
or air may be drawn into master cylinder.
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
2872189
e
one full turn. Close
NOTICE
© Copyright Polaris Industries Inc.