Polaris 2014 Sportsman 570 EF Service Manual page 91

21. Remove (-) negative cable(1) by removing the starter
mounting bolt.
22. Disconnect the upper engine coolant hose (H),
bypass hose (I) and ECT (J) harness connector.
23. Remove the exhaust springs and fasteners retaining
the exhaust manifold heat shields.
24. Remove the heat shields and exhaust pipe from the
vehicle to gain engine removal clearance.
NOTE: Dispose of exhaust seals at this time.
25. Remove front Prop shaft. (See
FRONT OR REAR, page 7.34)
26. Remove the fastener that connects the rear engine
mount to the frame.
27. Remove the front engine mounts to aid in engine
removal.
28. With the help of an assistant rotate the top of the
engine forward until the top of the cylinder head is
facing the front of the vehicle.
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
29. With the help of an assistant lift the engine and rotate
it out the frame opening at the left side of the vehicle.
NOTE:
supports.
30. Use an overhead or portable engine hoist and
suitable engine straps to secure the engine in its
current position.
NOTE: Have an assistant help guide the engine
in and out of the vehicle while using an engine
hoist to prevent personal injury or damage to the
vehicle components.
31. Install the engine stand adapter (PU-50824-A) onto
the engine PTO side mounting ears as shown below.
32. Select the proper engine stand sleeve adapter and
install it onto the engine stand adapter.
• Sleeve adapter for a 2" bore engine stand:
• (PU-50625)
• Sleeve adapter for a 2.375" bore engine stand:
• (PW-47054)
33. Place engine onto the engine stand (PU-50824-A)
for service.
PROP SHAFT -
© Copyright 2013 Polaris Sales Inc.
Rest the engine on the left footwell
ENGINE
3
3.33