Front Turn Signal Lamp Replacement; Pod Indicator Lamp / Switch Replacement; Speed Control - Polaris 2014 Sportsman 570 EF Service Manual

ELECTRICAL

Front Turn Signal Lamp Replacement

The front blinkers are non serviceable.
1. Remove the screw retaining the front turn signal
assembly.
2. Test the new light assembly.
3. Install the screws and tighten sufficiently.

Pod Indicator Lamp / Switch Replacement

1. Remove the screws from the pod assembly and lift
the upper pod off.
10.50
2. Disconnect the wiring harness of the assembly you
3. Press the retainer tabs using your fingers or a pliers
4. Insert a new assembly into the corresponding
5. Install the upper pod, screws and tighten sufficiently.

Speed Control

The speed control system utilizes the ECU, Speed
Sensor, Solenoid Valve, and engine vacuum from the
throttle body to operate. The ECU powers the system
through the ECU/IGN/FUEL Relay. When the speed
sensor signal rises over 40 Kph (25 Mph), the ECU
triggers the solenoid valve to open, allowing atmospheric
pressure on top of the air control body diaphragm which
limits the amount of air entering the engine. Once the
vehicle speed drops below 37-40 Kph (23-25 Mph), the
solenoid valve is closed by the ECU and the operation
repeats. Should the vehicle speed reach 67 Kph (42
Mph), the 'check engine' light will illuminate on the LCD
gauge to indicate there is a problem with the system.
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
© Copyright 2013 Polaris Sales Inc.
wish to replace.
and push the assembly out of the housing.
opening and install the harness.