Bushing Service - Polaris 2014 Sportsman 570 EF Service Manual

CLUTCHING
7. Remove moveable sheave and note the number of
spacer washers. One spacer must remain between
the sheaves when adjusting belt deflection.
6.30
8. Inspect the Teflon™ coating on the moveable sheave
Replace the bushing if more brass than Teflon™ is
9. Inspect driven clutch faces for wear or damage.
10. Clean and inspect splines on helix and transmission
11. Lube splines with a light film of grease. Do not

Bushing Service

Bushings are installed at the factory using Loctite™. In
order to remove the bushing it will be necessary to apply
heat. A press can be used to remove and install some of
the bushings. Be sure to support the sheave or cover as
close as possible to the bushing bore when using a
press.
1. Install Main Puller Adapter (#8) (PN 5020632) onto
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual
© Copyright 2013 Polaris Sales Inc.
bushing.
Moveable Sheave Bushing Inspection:
visible on the bushing. Refer to the "Bushing
Service" section.
input shaft.
lubricate the bushings!
the Piston Pin Puller (PN 2870386).