Engine Break-In Period; Engine Lubrication Specifications - Polaris 2014 Sportsman 570 EF Service Manual

Engine Break-In Period

The break-in period consists of the first 25 hours of
operation, or the time it takes to use 15 gallons (57 liters)
of fuel. Careful treatment of a new engine and drive
components will result in more efficient performance and
longer life for these components.
CAUTION
Use only Polaris PS-4
Synthetic Engine Oil.
Never substitute or mix oil brands.
Serious engine damage and voiding of warranty can
result.
Do not operate at full throttle or high speeds for
extended periods during the first three hours of use.
Excessive heat can build up and cause damage to
close fitted engine parts.
1. Fill fuel tank with unleaded fuel which has a minimum
pump octane number of 87 = (R+ M)/2.
2. Refer to Chapter 2, "Engine Oil Level". Check oil
level indicated on oil tank dipstick. Add oil if
necessary.
3. Drive slowly at first to gradually bring engine up to
operating temperature.
4. Vary throttle positions. Do not operate at sustained
idle or sustained high speed.
5. Perform regular checks on fluid levels, controls and
all important bolt torques.
6. Change oil and oil filter after break-in period at 25
hours.
9924871 R03 - 2014 Polaris Sportsman® 570 EFI Service Manual

Engine Lubrication Specifications

(using Polaris PS-4 at operating temperature)
© Copyright 2013 Polaris Sales Inc.
Oil Capacity:
Approx. 2 Quarts (1.9 L)
Oil Filter Wrench:
PU-50105 or 2.5" (64 mm)
Oil Type:
Polaris PS-4
Synthetic Engine Oil
Oil Pressure
Minimum Specification:
10 PSI @ 1200 RPM(Minimum)
40 PSI @ 7000 RPM (Minimum)
ENGINE
3
3.37