Receiving Side - Mitsubishi Electric MELSEC iQ-RJ71EN71 User Manual

12.
Write the protocol setting data to the CPU module.
[Online]  [Write to Module]
13.
Write the set parameters to the CPU module. Then reset the CPU module or power off and on the system.
[Online]  [Write to PLC]
In this example, default values were used for parameters that are not shown above. For the parameter setting,
refer to the chapter explaining the parameters in this manual. ( Page 241 PARAMETER SETTINGS)

■Receiving side

1.
Set the CPU module and add the module labels of the CPU module. The setting method of the CPU module and addition
method of the module label are the same as those of when setting the sending side. ( Page 50 Sending side)
2.
Set the RJ71EN71 and add the module labels of the RJ71EN71. The setting method of the RJ71EN71 and addition
method of the module label are the same as those of when setting the sending side. ( Page 50 Sending side)
3.
Set the items in "Basic Settings" as follows.
[Navigation window]  [Parameter]  [Module Information]  [RJ71EN71]  [Port 1 Module Parameter (Ethernet)] 
[Basic Settings]
1.3 Communications Using the Predefined Protocol
1
1 FUNCTIONS
55